LINGYUE ELECTRIC POWER

What should you pay attention to when installing UT cable clamp?

Release Time：2024-12-06

There are several points to pay attention to when installing UT cable clamps:

1. Apply grease to the threads before installation.

2. There should be no obvious loose strands in the bent part of the rope. The broken end of the rope should be securely fastened to the main rope. The length of the tail rope protruding at the clamp should be three to five centimeters. After turning back, the tail rope should be securely tied to the main rope.

3. The tongue plate of the cable clamp should fit tightly on the tension rope, and there should be no slipping after tensioning. The protruding part of the cable clamp is on the tail line side. Do not damage the wire strands during installation.

4. Use 3.2 mm galvanized iron wire to tie the wire. The long end of the tying wire should have fifteen turns and the short end should have five turns. The tail wire of the tying wire should be twisted and tied firmly. Leave the short end of the tie line 25mm away from the line, and the tie line should be level and taut.

5. After installing the nut on the UT type wire clamp, the protruding length of the screw thread should be one third of the total thread length. After tightening, the double nuts of the UT type wire clamp are tightened together.

6. When using double clamps and connecting plates for the same group of cables, the direction of the ends should be the same.